RPM-based manual data restore failed
If you are using an RPM system that is not rpm-ostree and tried to restore a manual backup, the following reasons can cause the restoration to fail:
-
If MicroShift stopped running because of an error, you cannot restore data.
-
Make sure the system is healthy.
-
Start it in a healthy state before attempting to restore data.
-
-
If you do not have enough storage space allocated for the incoming data, the restoration fails.
-
Make sure that your current system storage is configured to accept the restored data.
-
-
You are attempting to restore data from a newer version of MicroShift.
-
Ensure that the data you are restoring follows same versioning pattern as the update path. For example, if the destination version of MicroShift is an older version than the version of the MicroShift data you are attempting to use, the restoration can fail.
-