Red Hat build of MicroShift

cniVersion

string

The CNI specification version. A minimum version of 0.3.1 is required.

name

string

The mandatory, unique identifier assigned to this CNI network attachment definition. It is used by the container runtime to select the correct network configuration and serves as the key for persistent resource state management, such as IP address allocations.

type

string

The name of the CNI plugin to configure: bridge.

ipam

object

The configuration object for the IPAM CNI plugin. The plugin manages IP address assignment for the attachment definition.

bridge

string

Optional: Specify the name of the virtual bridge to use. If the bridge interface does not exist on the host, the bridge interface gets created. The default value is cni0.

ipMasq

boolean

Optional: Set to true to enable IP masquerading for traffic that leaves the virtual network. The source IP address for all traffic is rewritten to the bridge’s IP address. If the bridge does not have an IP address, this setting has no effect. The default value is false.

disableContainerInterface

boolean

Optional: Controls the container interface (veth peer inside the netns container). When set to true, the container interface link-state is set to down, you cannot use the IPAM CNI plugin. The default value is false.

isGateway

boolean

Optional: Set to true to assign an IP address to the bridge. The default value is false.

isDefaultGateway

boolean

Optional: Set to true to configure the bridge as the default gateway for the virtual network. The assigned IP address of the bridge is used as the default route. If isDefaultGateway is set to true, isGateway is also set to true automatically. The default value is false.

forceAddress

boolean

Optional: Set to true to allow assignment of a previously assigned IP address to the virtual bridge. When set to false, if an IPv4 address or an IPv6 address from overlapping subsets is assigned to the virtual bridge, an error occurs. The default value is false.

hairpinMode

boolean

Optional: Set to true to allow the virtual bridge to send an Ethernet frame back through the virtual port it was received on. This mode is also known as reflective relay. The default value is false.

promiscMode

boolean

Optional: Set to true to enable promiscuous mode on the bridge. The default value is false.

vlan

integer

Optional: Specify a virtual LAN (VLAN) tag as an integer value. By default, no VLAN tag is assigned.

preserveDefaultVlan

boolean

Optional: Indicates whether the default VLAN must be preserved on the veth end connected to the bridge. Defaults to false.

portIsolation

boolean

Optional: If true, prevents containers on the same bridge from communicating with each other. A container can still reach non-isolated ports. For example, a bridge interface that allows access to the host or an optional uplink that allows access outside the host. The default value is false.

vlanTrunk

list

Optional: Assign a VLAN trunk tag. The default value is none.

mtu

integer

Optional: Set the maximum transmission unit (MTU) to the specified value. The default value is automatically set by the kernel.

enabledad

boolean

Optional: Enables duplicate address detection for the container side veth. The default value is false.

macspoofchk

boolean

Optional: Enables mac spoof check, limiting the traffic originating from the container to the mac address of the interface. The default value is false.